Instruction Manual of Bovine Free Fatty Acid (FFA) ELISA Kit

Instruction Manual of Bovine Free Fatty Acid (FFA) ELISA Kit
This kit is for research use only.
Detection range: 96T
20μmol / L-480μmol / L
purpose of usage:
This kit is used to determine the content of free fatty acids (FFA) in bovine serum, plasma and related liquid samples.
Experimental principle
This kit uses the double antibody sandwich method to determine the level of bovine free fatty acid (FFA) in the specimen. The microtiter plate is coated with purified bovine free fatty acid (FFA) antibody to make a solid phase antibody. Free fatty acid (FFA) is added to the microwells coated with mAb in sequence, and then combined with HRP labeled free fatty acid (FFA) antibody To form an antibody-antigen-enzyme-labeled antibody complex, and after thorough washing, the substrate TMB is added for color development. TMB is converted into blue under the catalysis of HRP enzyme, and into the final yellow under the action of acid. The color depth is positively correlated with the free fatty acid (FFA) in the sample. The absorbance (OD value) was measured with a microplate reader at a wavelength of 450 nm, and the concentration of bovine free fatty acid (FFA) in the sample was calculated by a standard curve.
Kit composition
1
30 times concentrated washing solution
20ml × 1 bottle
7
Stop solution
6ml × 1 bottle
2
Enzyme reagent
6ml × 1 bottle
8
Standard product (1600μmol / L)
0.5ml × 1 bottle
3
Enzyme coated plate
12 holes × 8
9
Standard dilution
1.5ml × 1 bottle
4
Sample diluent
6ml × 1 bottle
10
Instructions
1 serving
5
Developer A liquid
6ml × 1 bottle
11
Sealing film
2 sheets
6
Developer B liquid
6ml × 1 / bottle
12
sealed bag
1
Specimen requirements
1. Specimens are extracted as soon as possible after collection, and extraction is performed according to relevant literature, and experiments should be conducted as soon as possible after extraction. If the test cannot be performed immediately, the specimen can be stored at -20 ℃, but repeated freezing and thawing should be avoided
2. The samples containing NaN3 cannot be detected because NaN3 inhibits horseradish peroxidase (HRP) activity.
Steps
1. Dilution of standard products: This kit provides one original standard product. The user can perform dilution in a small test tube according to the following chart.
800μmol / L
Standard No. 5
150μl of original standard is added to 150μl standard dilution
400μmol / L
Standard 4
150μl Standard No. 5 is added to 150μl standard dilution
200μmol / L
Standard 3
150μl Standard No. 4 is added to 150μl Standard Diluent
100μmol / L
Standard No. 2
150μl Standard No. 3 is added to 150μl Standard Diluent
50μmol / L
Standard 1
150μl Standard No. 2 is added to 150μl Standard Diluent
2. Sample addition: set up blank wells (the blank control wells do not add samples and enzyme reagents, the rest of the operation is the same), standard wells, sample wells to be tested. Accurately add 50μl of the standard on the enzyme-coated plate, add 40μl of sample diluent to the sample well, and then add 10μl of the sample to be tested (the final dilution of the sample is 5 times). Add the sample and add the sample to the bottom of the well of the microplate, try not to touch the wall of the well, shake gently to mix.
3. Incubation: Seal the plate with a sealing plate and incubate at 37 ° C for 30 minutes.
4. Mixing solution: Dilute 30 times concentrated washing liquid with distilled water 30 times and reserve
5. Washing: Carefully peel off the sealing film, discard the liquid, spin dry, fill each well with the washing liquid, let it stand for 30 seconds and then discard, repeat 5 times and pat dry.
6. Add enzyme: add 50μl of enzyme label reagent to each well, except blank well.
7. Incubation: The operation is the same as 3.
8. Washing: The operation is the same as 5.
9. Color development: add 50μl of developer A to each well, then add 50μl of developer B, mix gently, and develop at 37 ° C in the dark for 15 minutes.
10. Termination: Add 50μl of stop solution to each well to stop the reaction (at this time the blue will turn to yellow).
11. Determination: Measure the absorbance (OD value) of each well in sequence with the blank air conditioner at zero and 450 nm wavelength. The measurement should be carried out within 15 minutes after adding the stop solution.
Summary of operating procedures:
Calculation
Taking the concentration of the standard as the abscissa and the OD value as the ordinate, draw a standard curve on the coordinate paper, and find the corresponding concentration from the standard curve according to the OD value of the sample; then multiply it by the dilution factor; Calculate the linear regression equation of the standard curve with the OD value, substitute the OD value of the sample into the equation, calculate the sample concentration, and multiply it by the dilution factor to obtain the actual concentration of the sample.
Precautions
1. The kit should be equilibrated at room temperature for 15-30 minutes before being taken out of the refrigerated environment. If the enzyme label coated plate is unopened, the strip should be stored in a sealed bag.
2. Crystals may be precipitated in the concentrated washing liquid, which can be heated and dissolved in a water bath during dilution, and the results will not be affected during washing.
3. The sampler should be used at each step of sample addition, and the accuracy should be regularly checked to avoid test errors. It is best to control the sampling time within 5 minutes. If there are many specimens, it is recommended to use a volley gun to add samples.
4. Please make a standard curve at the same time of each measurement, it is best to make a double hole. If the content of the test substance in the specimen is too high (the OD value of the sample is greater than the OD value of the first well of the standard well), please first dilute it with a certain multiple (n times) of the sample diluent and then determine it. When calculating, please multiply the total dilution Multiple (× n × 5).
5. The sealing film is limited to one-time use to avoid cross-contamination.
6. Please keep the substrate away from light.
7. Strictly follow the instructions, and the test results must be determined by the microplate reader.
8. All samples, washing liquids and various wastes should be treated as infectious agents.
9. The components of different batches of this reagent shall not be mixed.
10. If there is any difference with the English manual, the English manual shall prevail.
Storage conditions and validity period
1. Kit storage :; 2-8 ℃.
2. Validity: 6 months
Instruction Manual of Bovine Free Fatty Acid (FFA) ELISA Kit

There is a famous saying that if you want to catch someone`s heart, you need to catch his/her stomach first. It is true that cooking a delicious meal for your love brings double happiness. Come to Taihua, we prepare everything for you and your kitchen.

 

One full set of kitchen room furniture usually consists of Island Cabinet, base cabinet, Wall Cabinet, pantry cabinet (Tall Cabinet).

 

For kitchen room furniture, we usually offer customizing service, because we know how important it is to fit every inch in the kitchen and make as much storage room as possible. Also, clients can choose from our variety of styles, materials and colors. We believe clients can always find the right kitchen in Taihua.

 

For other wooden furniture, we offer as many as 15 wooden colors and different sizes so that clients can fit their room well. Also, we offer size customizing service if the quantity meeting our MOQ. Clients` safety and health is always our priority, thus, we only use E0 standard raw materials. Besides the top quality raw materials, we also use top-quality hardware for more durability and stability, such as Blum, Hettich, Hafele, DTC.

Wall Cabinet

Hanging Cabinet,Wall Cabinet,Kitchen Wall Cabinets,Hanging Kitchen Cabinets

Hangzhou Taihua Home Furnishing Technology Co.,Ltd , https://www.taihuafurniture.com